BMW Motorcycle Coding by VVDI BIM Tool Pro

If you have a Tire Pressure Monitor malfunction DTC error after programming BMW 4D/8A motorcycle keys with VVDI Key Tool Plus or VVDI2, here is the working solution.

The problem can be solved by VVDI BIM Tool or VVDI BIMTool Pro programmer.

Connect BIMTool pro with laptop and motorcycle.

Run VVDI BMW software.

Go to “Program/Code” function.
Auto detect and connect Car to retrieve vehicle information.

Select Vehicle Programming.
Make sure “target istufen lev” is the same as the “Shipment date”.

If there is no shipment date available, choose the latest one.

Click on “FEM” and press “Calculate programming file”, press Yes to confirm

BMW Motorcycle Coding by VVDI BIM Tool Pro 6

The calculation is completed.

Gray areas indicate the current module version information.

Orange areas indicate the programmable version information.

Click Programming to proceed.
Auto input VIN code.
Programming finished.

BMW Motorcycle Coding by VVDI BIM Tool Pro 11

After programming is completed. Read and clear DTCs.

No DTC display on BMW motorcycle dashboard.

Done.

www.vvdishop.com

Comments

How to Solve VVDI BIMTool Error 211?

The Xhorse VVDI BIMTool Pro reports error 211 when I was trying to flash an EGS transmission. “Error:211 Error om flash programming Programming state invalid.” Solution: Slow down the communication speed between the vvdi bimtool and the control unit. Go to Option tab- Parameters settings – change programming speed to 1 (it is three by default). Read also: Xhorse VVDI BIMTool Pro Read BMW MSD80 ISN and Change VIN Success

VVDI BIMTool Pro BMW FEM BDC KM Reset Guide

Tutorial: BMW Series F series Reset FEM BDC mileage eeprom 95128-95256 using Xhorse VVDI BIMTool Pro . i.e. F20 FEM module Procedure: Remove BMW FEM module from the vehicle Set up bench connection. Connect VVDI BIMTool pro with godiag BMW FEM test platform , FEM module, feed vvdi with 12v+ power supply (very important) Turn on ignition switch of the godiag test platform Run Xhorse vvdi bim tool software , go to BMW/FEN Key Learn and Get key Information As you can see 2 keys are programmed and you can see VIN and current mileage is 183374 KM Press Reset KM BIMTool will ask to program FEM/BDC first Press Program BMW FEM/BDC System Follow 4 steps to program BMW FEM/BDC Step 1. Backup coding Read FEM/BDC coding ia OBDII or on bench Step 2. Prepare service EEPROM Open FEM/BDC shell, find 95128/95256 chip position, read EEPROM dump via BDM programmer Load original eeprom dump and save special EEPROM dump, write special EEPROM dump back to...

Xhorse VVDI BIMTool Pro Cannot Test Frequency Solution

Problem: I had a problem with Xhorse VVDI Bimtool Pro when I try to check the frequency of the key but it is in Chinese. I am pressing the “F” button and nothing happens when i try to press key buttons. i Have allready update firmware to 1.8.4 Version but nothing changed. The “T” button for transponder works fine. Solution: Press F, wait 2 seconds press F again followed by an immediate press from the remote, make sure the key is fully flat perpendicular on the blue area. 315Mhz,434Mhz tested fine. To change the Chinese language, double hold both F and T buttons for 5 seconds, it will change the language to English. Same as VVDI2 .

Xhorse VVDI BIM Tool Pro

Search This Blog