There are some speical functions of Xhorse VVDI BIMTool pro under Fxx/Gxx Program/Code menu. Here comes the explanation of these special functions.
Function Introduction:
1. Switch ON/OFF transport mode: if in transport mode car not start, you can usethis function
2. Reset FEM to start: change module, if after change configuration data can‟tstart car because motor, you can use this function
3. Emergency switch ON: When all key lost or the ELV is off, the FEM/BDC/CAS4system can be programmed after turning on the ignition switch ON
4. Update gateway InstallECUlist: Update gateway Install ECU list
5. Reset FlexRay: Reset FlexRay will reset the internal FlexRay of the gateway.
Attention: Before this operation, you need to write the gateway control unit list first and reset FlexRay then reinitialize FlexRay
6. Initialize FlexRay: Initializing FlexRay will reset the internal FlexRay of the gateway. Before performing this function, make sure that all modules have been installed on car and communicate normally! After initializing FlexRay, if error codeof the vehicle appears, power off the vehicle for ten minutes it will work
7. Update MSM: MSM contains the SVT file information of all modules. Generally,this operation does not need to be performed. To perform this operation, you need to load the SVT file containing all the control unit information. The SVT file will besaved on the computer by default when the vehicle information is read.
The defaultsave path: My Computer>Documents>BMWTOOL>CARINFO_BACK>The VIN named folder
8. Reset ELV: This function is used to replace the FEM/BDC, and the ignitionswitch can be turned on after resetting the ELV
9. FSC Tool: Update the navigation file information.
Calculate activate code: NBT host uses DE type FSC file to calculate activate code, CIC host uses 1B type FSC file to calculate activate code
Read: read “VIN”, “Base Variant”Read FSC information: read license information
Backup FSC file: backup license information
Write FSC file: write license information
Uninstall license: Uninstall unnecessary license
Delete license: delete unnecessary license
Restart unit: Restart the navigation control unit module
10. VCM Tool: Mainly for read, write and backup VCM data
Main function introduction: Read VCM data from the gateway, including the FA configuration informationof the vehicle. For example: when a module containing FA information needs to be programmed separately on the bench, and the configuration information of the bench is different with the module, you can read the backup VCM information fromother module of the original vehicle that has not lost information, and then write theinformation into the module. Other modules, such as instrumentation, FEM, foot space module. When the programming coding information of some modules of the vehicle is lost, you can get all the information from here, and loading this information can restore the programming and coding information of the lost module
11. Initialize Airbag: It needs to use this function after repairing or replacing the airbag, otherwise the airbag will be abnormal
12. Reset EKPS production mode: Generally, after replacing the EKSP control unit need Reset EKPS Produce mode
13. Customer request: Send the code to the car, check the model information, and judge the problem through the vehicle’s feedback. For example: send the message 22F190,you can get the VIN
Comments
Post a Comment